[Donia330i]

Trying to see what's reasonable. What's the going rate for spring install? More specifically Dinan springs and handling kit. Thanks!

[njfoses]

$500 or so for the well known Atlanta shops. Less at the pop up type shops or driveway install.

[Donia330i]

Originally Posted by njfoses

$500 or so for the well known Atlanta shops. Less at the pop up type shops or driveway install.

Can you recommend any shops here?

[RedKloud]

I was quoted up to $1200 for Dinan springs on my F30. Ultimately paid $550.

[njfoses]

Originally Posted by Donia330i

Can you recommend any shops here?

Solo Motorsports, Eurofed and i have heard good things about High Tech Suspension which is a newer shop in the area.

[Donia330i]

Originally Posted by njfoses

Solo Motorsports, Eurofed and i have heard good things about High Tech Suspension which is a newer shop in the area.

Eurofed wants $700 with alignment

[njfoses]

Originally Posted by Donia330i

Eurofed wants $700 with alignment

I did not include alignment in my guesstimate as usually that is done after the springs have settled for a few weeks. Many, many options for an alignment in Atlanta.

I am assuming you also posted in the atlbimmer FB group? If so, make sure you tell the shops you are a member there and were referred. They will give you a bit of a discount.

[Donia330i]

Originally Posted by njfoses

I did not include alignment in my guesstimate as usually that is done after the springs have settled for a few weeks. Many, many options for an alignment in Atlanta.

I am assuming you also posted in the atlbimmer FB group? If so, make sure you tell the shops you are a member there and were referred. They will give you a bit of a discount.

I did. Lol! ok thanks. Where in Atlanta are you located?

[12v_dub]

3 hr job in my garage using a good quality spring compressor.

[12v_dub]

Originally Posted by Donia330i

Trying to see what's reasonable. What's the going rate for spring install? More specifically Dinan springs and handling kit. Thanks!

PM me if you still need it done.

[Donia330i]

Originally Posted by 12v_dub

PM me if you still need it done.

You still around?

[mike@x-ph.com]

No more than $500

It's a 3 hours job and most mechanics charge $100 - $150 per hour