[ole85]

     Featured on BIMMERPOST.com

Does anybody know if it’s possible to install the akra mid pipe to the stock rear muffler section

[WraithM5]

I am considering this as well! very curious to see if this is possible.

[black_vicking]

Originally Posted by ole85

Does anybody know if it’s possible to install the akra mid pipe to the stock rear muffler section

I am an Akrapovic dealer. Shoot me a message on monday to find out for you.

[Nkr15]

Originally Posted by black_vicking

I am an Akrapovic dealer. Shoot me a message on monday to find out for you.

Can you find out if there's a way to put on akrapovic without cutting stock exhaust please

[Soylent]

Originally Posted by Nkr15

Can you find out if there's a way to put on akrapovic without cutting stock exhaust please

Wouldn't you just buy the entire catback system? Then you can drop the oem right out without cutting

[moproblems]

If you want to separate the factory midpipe from the muffler you need to cut it end of story. There's no flange.

[PLife]

Waste of money i think everything sounds similar with the stock rear box just get the best flowing steel mid pipe

[Nkr15]

Originally Posted by Soylent

Wouldn't you just buy the entire catback system? Then you can drop the oem right out without cutting

I don't think so the link pipe and slip on you need to cut stuff I think it uses the stock primary cats maybe turbo back you might not have to cut I'm not sure which is why I'm asking. Id rather just raise the car and swap exhausts with a wrench than go to a shop.

[Soylent]

Originally Posted by Nkr15

I don't think so the link pipe and slip on you need to cut stuff I think it uses the stock primary cats maybe turbo back you might not have to cut I'm not sure which is why I'm asking. Id rather just raise the car and swap exhausts with a wrench than go to a shop.

It was a rhetorical question. Only way is complete catback or you cut out the muffler at the center dots.

[black_vicking]

Originally Posted by Nkr15

Can you find out if there's a way to put on akrapovic without cutting stock exhaust please

Sorry about the delay I don't get in here much unless I get inbox notification. I believe is not possible but Ill find out for you.

[iviegatron]

Originally Posted by black_vicking

Sorry about the delay I don't get in here much unless I get inbox notification. I believe is not possible but Ill find out for you.

As the poster above mentioned, the stock exhaust is a full piece. If you're replacing just the midpipe then you have no choice but to cut, unless you're replacing the full exhaust.