[adr_M3]

A fellow forum member posed this question but I thought I'd get a separate thread started. Has anyone replaced their stock bushings with ball joints like the following:

https://www.dinancars.com/products/s...arts/D280-0024

I didn't find any examples of people doing this mod on prior M models let alone the M3/M4 but if this improves steering feel with limited to no downside then it seems compelling.

[Itson451]

That was me, I have the fall line g80 monoball. I bought it because the dinan version is not compatible with xdrive

[adr_M3]

Originally Posted by Itson451

That was me, I have the fall line g80 monoball. I bought it because the dinan version is not compatible with xdrive

Is there a noticeable improvement in the steering feel dynamic vs stock? Are there any material downsides such as added NVH post-install?

[Itson451]

Originally Posted by adr_M3

Is there a noticeable improvement in the steering feel dynamic vs stock? Are there any material downsides such as added NVH post-install?

Check out the fall line g80 monoball thread I started, I hope this helps

[adr_M3]

Originally Posted by Itson451

Check out the fall line g80 monoball thread I started, I hope this helps

Found it, thanks!

[tsixtial]

I will never purchase a DINAN product ever again lol... I just recently installed their Valve controller and it was a nightmare.

[Itson451]

Originally Posted by tsixtial

I will never purchase a DINAN product ever again lol... I just recently installed their Valve controller and it was a nightmare.

Seems like Dinan is behind the 8ball with the g8x cars with very few products