[10ORIO]

Does anyone have the wiring schematics for DME 8.6.S. Need direction on what the PTCAN connector looks like or pinout # to install flex fuel kit to work with BM3. TIA.

[ZheroG80]

Originally Posted by 10ORIO

Does anyone have the wiring schematics for DME 8.6.S. Need direction on what the PTCAN connector looks like or pinout # to install flex fuel kit to work with BM3. TIA.

The only kits I have seen tie into the CANBUS wires under the glovebox. My kit from Visconti pairs right with BM3 and auto adjusts.

[10ORIO]

That’s exactly what I’m after but I’m not too keen on having to pay $700 for a kit I can piece together myself for a fraction of the price.

[ZheroG80]

Originally Posted by 10ORIO

That’s exactly what I’m after but I’m not too keen on having to pay $700 for a kit I can piece together myself for a fraction of the price.

Can you just tap in to the connector that houses the 2 yellow canbus wires?

[10ORIO]

Yes. I’ll be doing that near the DME but I want to make sure I have the correct wires. Hence the need for the diagram or pinout schematics.