[spicoli024]

Originally Posted by ROBERT1183

LMAO lol nope. Im not sure if Autocouture heated the liner and massaged it to make it not rub.

I would assume they wouldn’t do that without your permission. Anyway, headed back to the shop now to see what can be done. Thanks for the info!

[ROBERT1183]

Originally Posted by spicoli024

I would assume they wouldn’t do that without your permission. Anyway, headed back to the shop now to see what can be done. Thanks for the info!

When I originally made the appt I told them if they could do it while on the lift

[ROBERT1183]

Originally Posted by keiridin

When you get a chance, can you measure from the bottom of the rim to the bottom of the front and rear fender? I'd like to compare to my KW HAS drop but I don't have the original height. I only know that I sit 24 1/4" on the front and 24 3/4" on the rear. Both have about a 1/4 of the threads left. I think I want to drop a bit lower.

Im at 24 1/4'' on the front and just over 24'' on the rear

[mike@x-ph.com]

Originally Posted by ROBERT1183

Im at 24 1/4'' on the front and just over 24'' on the rear

[rsquare]

Did everyone install right away or wait for the break in service?

[ROBERT1183]

Originally Posted by rsquare

Did everyone install right away or wait for the break in service?

I did not do my break in service yet. Only at 7xx miles. Im in NJ and car is pretty much away til spring.

[keiridin]

Originally Posted by ROBERT1183

Im at 24 1/4'' on the front and just over 24'' on the rear

Thanks for checking. It sounds like you are sitting at about the same height as I am. I have a bout 1/4 threads left all around. I'm considering dropping the front a bit more. Maybe by a 1/2 inch.

[JTO24]

I might have ACM swap my AST springs for this.. I can't get rid of this creaking noise coming from the front. At this point after multiple shops and multiple attempts to fix it, it must be related to the ast springs themselves. This KW has drop looks great!

[ROBERT1183]

Originally Posted by JTO24

I might have ACM swap my AST springs for this.. I can't get rid of this creaking noise coming from the front. At this point after multiple shops and multiple attempts to fix it, it must be related to the ast springs themselves. This KW has drop looks great!

Thank you!! I was gonna go with the AST until I saw a few KW. Had the Kw on my F80 and loved them.

[BIGW0RM]

Originally Posted by ROBERT1183

Im at 24 1/4'' on the front and just over 24'' on the rear

Thank you for posting this. I just measured my stock G80 M3 comp and I am exactly 1" higher front and back.

25, 1/4" front
25" rear.

So this is good news to me because i do not want to have to slam my front to get equal or very close to equal wheel gap.

Thanks again for the measurements and confirming that you are not max low up front.

[tom @ eas]

Originally Posted by BIGW0RM

Thank you for posting this. I just measured my stock G80 M3 comp and I am exactly 1" higher front and back.

25, 1/4" front
25" rear.

So this is good news to me because i do not want to have to slam my front to get equal or very close to equal wheel gap.

Thanks again for the measurements and confirming that you are not max low up front.

We still have about another ~10mm adjustment range in rear when setting for 1 finger gap.