11-26-2023, 09:26 PM | #1 |
Private First Class
99
Rep 110
Posts |
G80/G82 Aftermarket Wheel Specs Differences
Hello all,
Looking to purchase a set of wheels off of someone with a G82 M4, I own a G80 M3. Are wheel specs pretty much the same for both? |
11-26-2023, 09:50 PM | #2 |
Second Lieutenant
392
Rep 256
Posts
Drives: '24 M3 Comp X-Drive
Join Date: Nov 2021
Location: Southern MD
|
I was curious about this also. I want to lean towards them probably being the same.
__________________
Haters gonna' hate, ainters gonna' aint.
|
Appreciate
0
|
11-27-2023, 02:11 PM | #3 |
Lieutenant Colonel
2534
Rep 1,901
Posts |
Why would you think that? Bmw has 4 models, g80, g81, g82, g83 no way they would have 4 different spec of rims. Only the g87 wheels are different, they're cast rather than forged.
__________________
|
Appreciate
0
|
11-28-2023, 02:26 PM | #4 |
Private First Class
99
Rep 110
Posts |
Referring to aftermarket wheels with specific fitment. I assume they’re the same but just wanted to make sure beforehand
|
Appreciate
0
|
11-28-2023, 02:53 PM | #5 |
Major General
5450
Rep 5,139
Posts |
Yes, G80 and G82 interchange stock wheels no problem. If you’re swapping aftermarket then check the Apex Wheel G8X fitment guide for tested sizes, offsets and advice.
__________________
'18 F80 Base 6MT | '19 F82 Exec DCT | '18 F82 Comp Exec DCT | '23 G80cx
|
Appreciate
0
|
11-29-2023, 09:22 PM | #6 |
Lieutenant
1401
Rep 531
Posts |
The m4 is a tad wider. My buddy figured that one out. He swapped wheels (an 11 inch wide wheel with a +10 offset) that sat flush on a G80. He needed to put a tiny spacer on to get them flush on his M4. He ended up ordering his own set of the same wheels with a +7 offset.
|
Appreciate
1
g80.dre99.00 |
11-30-2023, 10:11 PM | #8 |
First Lieutenant
292
Rep 378
Posts |
If you go after market also check centerbore and bolt size if you want to easy swap yourself and use the same bolts.
Center Bore (DIA): 66.5 mm PCD: 5x112 Thread Size: M14 x 1.25
__________________
15 F80 YMB DCT - retired
14 F30 MSport MG/CR 6MT - retired |
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|