[greengoblinm3]

     Featured on BIMMERPOST.com

Wondering if anyone tried opening valve of their m3 or m4 using bimmercode or link

[f82_gold]

Dont think it is supported yet for the G platform. Specifically app notes state only S55

[greengoblinm3]

Originally Posted by f82_gold

Dont think it is supported yet for the G platform. Specifically app notes state only S55

It works for the G20 m340 for example

[Flying05]

Originally Posted by greengoblinm3

It works for the G20 m340 for example

Fully open? I hear that our valves are never fully open at any point. Have a VSC on order.

[greengoblinm3]

Originally Posted by Flying05

Fully open? I hear that our valves are never fully open at any point. Have a VSC on order.

The G20 supports bimmercode/link switching valves to be open always. 70 or 100% we dont know. What I wanted to know was if the program supports G80 too

[playswcars]

Not yet for the G80 unfortunately.

[g80luca]

Does anyone know when the exhaust function will be available in BimmerLink to fully open them. It seems to work on my buddy’s 2021 m340 but not on my 2023 m3.

[Hit_Apex]

Originally Posted by g80luca

Does anyone know when the exhaust function will be available in BimmerLink to fully open them. It seems to work on my buddy’s 2021 m340 but not on my 2023 m3.

No. Zero people here know this. I doubt they’re working on it, but go ahead and email them and report back.

[Berzerker]

Originally Posted by g80luca

Does anyone know when the exhaust function will be available in BimmerLink to fully open them. It seems to work on my buddy’s 2021 m340 but not on my 2023 m3.

Impossible with software. You need a valve controller

[Trotz]

I went with an IRL valve controller. Be here by the end of the week hopefully have it installed next week