02-23-2024, 02:27 PM | #178 | |
Captain
![]() ![]() ![]() ![]() 436
Rep 939
Posts |
Quote:
Let us know how the tape holds up. |
|
Appreciate
1
Tobster3634.00 |
03-29-2024, 08:38 AM | #180 |
Lieutenant Colonel
![]() ![]() 2567
Rep 1,929
Posts |
You need to use spacers and longer screws, they don't sit flush on my 23 either.
__________________
|
Appreciate
0
|
03-29-2024, 10:17 AM | #182 |
New Member
8
Rep 25
Posts |
The '24 Comp's liner is held with hex bolts far inside the wheel well, and as provided, the TLG flaps' extended screws are incompatible to hold the flap flush against the wheel well edge. If it were to be attached as expected, the flap would be pulled and turned in the wheel well in order to be secured. That's not the way it's supposed to fit, not what TLG's instructions show.
|
Appreciate
0
|
04-07-2024, 07:44 PM | #183 |
Private First Class
![]() 222
Rep 146
Posts |
Anyone have any recommendations/tips for installing the push pin rivets? I was able to install 3 out of 4 but kept bending the pins when trying to install the last one. I didn’t have any luck tapping any of them in with a hammer. The only way I was able to successfully install three of them was by holding the hammer against the pin and pushing as hard as possible. I’m using an 8oz ball and peen hammer; should I be using a heavier one?
Unfortunately I bent all of the extras that were provided so am currently waiting for the extras to arrive via Amazon. |
Appreciate
0
|
04-07-2024, 08:39 PM | #184 | |
Registered
![]() 3
Rep 3
Posts |
Quote:
These flaps definitely do the job! |
|
Appreciate
0
|
04-10-2024, 01:15 PM | #186 |
Second Lieutenant
![]() 130
Rep 247
Posts |
These ones come in Gloss Black, I just ordered a set
https://g80.bimmerpost.com/forums/sh...1891632&page=7 |
Appreciate
0
|
04-10-2024, 02:07 PM | #187 |
Captain
![]() ![]() ![]() ![]() 436
Rep 939
Posts |
|
Appreciate
0
|
04-14-2024, 03:04 PM | #189 |
First Lieutenant
![]() ![]() ![]() 274
Rep 310
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|