[Vernmeister]

I have a manual 24 g80. One of the first things I did was replace the grill with a vorsteiner grill.

I wanted mesh behind it for protection but also I liked the look more than it just being so open. Vorsteiner sells a mesh you can add on but I didn’t like the pattern.

I got some automotive mesh I liked off Amazon and cut it to fit myself and epoxied it in. Worked really well.

You could do something similar

(I also replaced the intakes)

[yocubed]

Originally Posted by Vernmeister

I have a manual 24 g80. One of the first things I did was replace the grill with a vorsteiner grill.

I wanted mesh behind it for protection but also I liked the look more than it just being so open. Vorsteiner sells a mesh you can add on but I didn’t like the pattern.

I got some automotive mesh I liked off Amazon and cut it to fit myself and epoxied it in. Worked really well.

You could do something similar

(I also replaced the intakes)

That actually looks really good. Link to the mesh you used?

[Vernmeister]

Originally Posted by yocubed

That actually looks really good. Link to the mesh you used?

AggAuto Universal 40"x13" Car Grill Mesh - Aluminum Alloy Automotive Grille Insert Bumper 10x20mm Rhombic Hole, One of the Most Multifunctional Shape Grids 100x33cm Black
https://a.co/d/idoWcrv

Thanks. I think it turned out really well.

I got a few different versions of the mesh. Initially wanted it to have a finer mesh but I worried it may restrict air flow so went with the larger rhombus pattern

[jrhav]

Originally Posted by Vernmeister

Thanks. I think it turned out really well.

I think it looks great. Hard to tell from the pics --- how did you secure it? Zip ties?

[Vernmeister]

Originally Posted by jrhav

I think it looks great. Hard to tell from the pics —- how did you secure it? Zip ties?

https://a.co/d/g3LeWH2

I cut and shaped the mesh so it hung over the edges about 2 cm. Secured the mesh tightly at the bottom with duct tape wrapped around. Globbed epoxy into mesh and let it run down between the mesh and the plastic/ carbon grill and intakes. Allowed it to cure and removed tape.

[nosbocaj]

Originally Posted by jrhav

I think it looks great. Hard to tell from the pics —- how did you secure it? Zip ties?

I did the same thing, though I secured mine with black 3M double sided tape. Works great and I wanted something that would be easier than epoxy or glue to remove if I changed my mind down the road.