[F1zbo]

Hi guys,

Just got my g80 back from my dealer after installing the H&R VTF HAS-kit.

I agreed with the mechanic to drive it over the weekend in order to have everything settle and then make the alignment and any final adjustments to the ride height next week.

So far I am super happy both with the appearance but also the ride quality, which is as comfortable as stock
Was not expecting that.

I also added 11mm spacers all round to give that oem+ look.

Super happy so far. Will give it the weekend to decide if I want to go lower or not.

[mieh100]

Very nice sir. Looks really clean. The drop is on point. What is the drop on the front ?

[f30dreamin]

Looks great! I can’t wait to get my car. Any rubbing issues with the spacers?

[F1zbo]

Originally Posted by mieh100

Very nice sir. Looks really clean. The drop is on point. What is the drop on the front ?

Thank you. About 1-1.2 inches I believe (2.5-3cm)
Will measure again next week when doing the alignment for final drop figures.

[F1zbo]

Originally Posted by f30dreamin

Looks great! I can’t wait to get my car. Any rubbing issues with the spacers?

Thanks.
No rubbing so far, but have not driven too much to test all scenarios to confirm.
However, 11mm with P4S is quite conservative, so should be fine.

[mike@x-ph.com]

Congrats, that's my favorite street kit

[F1zbo]

After a few days I think it has settled and I am happy with the drop as is.
Just got it aligned and it was quite a lot of camber on the rear after the drop hut nothing that was not possible to adjust to factory specs. Same goes for the front.

I did have some slight rubbung on the rear fender liner/plastic arch widener so that was removed during the alignment.
I think it also looks better without it.

[mike@x-ph.com]

Looks great

[F1zbo]

Originally Posted by mike@x-ph.com

Looks great

Thank you