05-14-2024, 08:44 AM | #1 |
Private First Class
76
Rep 117
Posts |
Fastest BM3 OTS Passes In Here!
Like the title says.... post up your fastest passes with OTS tunes and list your mods! Last Thursday I was able to run a 10.1@133 on the stage 2 E50 map from BM3. Mods to the car are as follows:
Femto Unlock BM3 OTS tune Mad Fatboy downpipes BM3 Flexfuel sensor XHP stage 3 trans flash DA at the time was almost 2600 ft. I'll be running this tune for a bit until they release their newer multimap. On a funnier note I drove 2 hours to the strip on a work night. When I got their I noticed I picked up a nail.... Had to leave, repair the tire, and come back. 1st run back was a 10.1....... after that I think the heat was causing it to pull timing a bit.... I had a few 10.3's and a 10.4.... but still happy with that 10.1! |
05-14-2024, 08:51 AM | #2 |
First Lieutenant
230
Rep 338
Posts |
That trap speed is right in line with what the OTS E50 tune provides.
I have seen a 134, which clearly you could have gotten in better DA. Great run! |
Appreciate
1
Jasinedward76.00 |
05-21-2024, 05:54 AM | #3 |
Private
433
Rep 70
Posts |
Almost a 9 sec pass!
I have a M2 and still waiting on my drag pack so my 60ft isn’t there yet but I went to the track last Sunday and I was happy to touch the 10s! OTS BM3 93 VRSF DP Dual Midpipe Drop in filter Around 85F ambient temp. Those OTS tune are not bad! I’m gonna go Cedar E50 soon and shooting for 9.9 Good job! |
Appreciate
4
|
05-21-2024, 07:21 AM | #4 | |
Private First Class
76
Rep 117
Posts |
Quote:
|
|
Appreciate
0
|
05-21-2024, 10:11 AM | #5 |
BimmerPost Supporting Vendor
2041
Rep 5,100
Posts |
Crazy fast for those mods!
__________________
|
Appreciate
0
|
05-21-2024, 11:38 AM | #6 |
BimmerPost Supporting Vendor
24528
Rep 191,521
Posts |
Nice
__________________
Check out our current sale by clicking on this link!
https://x-ph.com/sale/ Phone number 702-494-9435 |
Appreciate
0
|
05-21-2024, 12:39 PM | #7 |
Private First Class
76
Rep 117
Posts |
I was really close to running an aliexpress downpipe set when you guys got a shipment of fatboys in.... Honestly the prices you guys are asking is a much better deal. Not to mention the shipping took 2 days.
I think a single midpipe and lower weight axleback will get me into the 9's with this e50 tune. DA was almost 3000ft for this run and a correction showed me at 10.0@135.... with a little weight savings I'm sure I could have shaved a bit more off. I still can't believe I'm cutting 1.5 60' times on these Pirellis..... the 1st mod on my old Mustangs was always to remove those! |
Appreciate
0
|
05-21-2024, 12:44 PM | #8 | |
BimmerPost Supporting Vendor
2041
Rep 5,100
Posts |
Quote:
Thank for choosing us Lets get those 9's!
__________________
|
|
Appreciate
0
|
05-22-2024, 05:38 PM | #9 |
Major General
5539
Rep 5,214
Posts |
Jasinedward
I highly recommend Paul. His E50 tune got me down to a ‘Dragy Valid’ 6.13s 60-130 on stock engine/turbos/cats, with XHP/tires/intakes/exhaust. I’ve also run high 5.95-.85 but they got flagged for a minor bit of slope. His team gives a very good tuning experience…not a here-ya-go, one rev and goodbye like others.
__________________
'18 F80 Base 6MT | '19 F82 Exec DCT | '18 F82 Comp Exec DCT | '23 G80cx
|
Appreciate
1
Jasinedward76.00 |
05-22-2024, 07:14 PM | #10 | |
Private First Class
76
Rep 117
Posts |
Quote:
|
|
Appreciate
0
|
05-22-2024, 07:38 PM | #11 | |
Major General
5539
Rep 5,214
Posts |
Quote:
For full power I’d ask for a Flex tune that does from 93 up to E45-50. If you ask to run beyond E50 the tune has to cut power because fueling becomes limited.
__________________
'18 F80 Base 6MT | '19 F82 Exec DCT | '18 F82 Comp Exec DCT | '23 G80cx
|
|
Appreciate
1
Jasinedward76.00 |
Post Reply |
Bookmarks |
|
|