MPerformance Rear Wing just installed
Got it from IND.
Installation wasn't too hard BUT BE CAREFUL
The 4 mounting holes for the base plate need to drill through the inside panel not outside. when drilling it's very easy to create a dimple on the outside panel when the drill finally goes through. Sadly this has been learned the hardway. Fortunately, they weren't obvious at all though.
I didn't use any glue but use 3m tape to secure the wing and create some sort of water seal(even though the washer has O-ring on top of it) Also used a touch-up clear coat to cover the bare metal to prevent rust.
View post on imgur.com
View post on imgur.com