Quote:
Originally Posted by anakratis
There’s three factory cut points on either side marked by a set of dimples. Most use what I explained. Perhaps it might mate? At that point you’re just hoping the pipe clamp is long enough.
|
That's what I'm trying to decipher as well. The single mid look to cut the front of car dimple on the driver side and the mid dimple on the passenger.
This exhaust if mated to the factory center section would cut the mid dimple on both sides.
I feel like this exhaust wouldn't reach an aftermarket center mid pipe by about one dimple length.
A clamp would need to span that distance.
Can anyone actually confirm a fitment this way, I would lean to speculate that it DOESN'T fit rather than Fits, but I wouldn't know til I tried.