Quote:
Originally Posted by Jset7
Very nice sounding. Can the factory exhaust tips be used in place of the Dinan provided ones?
|
Would not, besides the different mounting methods (slip-on vs. clamp-on) the stock tips go onto a stock 3.18" pipe whereas the Dinan tips go onto a 3" pipe so a stock tip would be pretty loose on the Dinan exhaust even if you did figure a way to secure it.
Quote:
Originally Posted by hamzag20
Definitely looks good, curious about whether the axleback will fit onto my Valvetronic Single Mid.
|
Couldn't say definitively as its never been tested but assuming the valvetronic single mid uses the same factory cut points than there is little reason why it shouldn't mate.