[timeout]

Sooo…

Unknowingly parked my BSM G80 next to a sprinkler. One side of it has a decent amount of water spots.

What else can I do to try and remove before polishing?

If I delay polishing, do I risk the current water spots increasing damage if they are already etched in, ie is it like rot that will continue to eat away? I can live with them if not.

20 hours after exposure I tried:
- Quick detail wipe - no luck
- Spray with water - no luck
- 2 bucket wash - no luck

48-72 hours
- Meguiars 47 (RV/boat) spot remover - no luck
- Meguiars water spot remover for cars - removed the water spot but leaves a hazy looking portion where I used it when I apply the pressure required to remove it. If I don’t apply a lot of pressure, it doesn’t remove it.

96 hours
- Mega clay - no luck

I can feel the rough surface when I run my hands over areas with the water spots still. Am I not being aggressive enough w/ clay?

Thank you.