Quote:
Originally Posted by hamzag20
Curious about how you managed your valve cables and how low do your inlet pipes sit. I ended up drilling a hole in my head shield and zip tied the wires to the shield.
|
I did drill two holes on each side and then removed parts of the heat shield. Tucked the wires behind it and zip tied them down through the holes. It’s pretty much out of the way at that point.
The inlet pipe hangs low but it’s still a bit above the diff so I’m not too worried. You definitely can see it if you’re looking from behind. When first fitting everything I noticed that too but once everything was tighten it looked ok.