Quote:
Originally Posted by Technic
The center channel has the same 25Wp of the other 6-channels of the RAM - RAM outputs are set to the default 4-16Vrms channels A-F inputs of the UP 10DSP (25Wp = 10Vp = 7Vrms).
The Booster outputs (~26Vp = ~90Wp) must be set to 8-32Vrms of channels G-H of the UP 10DSP (26Vp = ~20Vrms).
You can fine tune the input levels at the DSP PC-Tool Signal Management -> Input Gain -> Advance Gain Setup screen. This will solve any high volume issues with the OEM gongs, PDC and prompts.
|
The amp is all-or-nothing though, right? You either put the single jumper on J1 (4-16V) or J2 (8-32V) for the whole system.
And I'm assuming the harness routes the outputs to the right channels in the 10DSP (25W to A-F and 90W to G-H), not like you can hook them up incorrectly.