Quote:
Originally Posted by Skyscraper
Correct. But I spoke to the factory USA tech. He said the center channel only isn’t high voltage and to leave it at low voltage.
The amp is working good in this configuration.
The sound is very bright. I need to spend some time adjusting
|
The center channel has the same 25Wp of the other 6-channels of the RAM - RAM outputs are set to the default 4-16Vrms channels A-F inputs of the UP 10DSP (25Wp = 10Vp = 7Vrms).
The Booster outputs (~26Vp = ~90Wp) must be set to 8-32Vrms of channels G-H of the UP 10DSP (26Vp = ~20Vrms).
You can fine tune the input levels at the DSP PC-Tool Signal Management -> Input Gain -> Advance Gain Setup screen. This will solve any high volume issues with the OEM gongs, PDC and prompts.