Quote:
Originally Posted by Dinan_Engineering
Would not, besides the different mounting methods (slip-on vs. clamp-on) the stock tips go onto a stock 3.18" pipe whereas the Dinan tips go onto a 3" pipe so a stock tip would be pretty loose on the Dinan exhaust even if you did figure a way to secure it.
Couldn't say definitively as its never been tested but assuming the valvetronic single mid uses the same factory cut points than there is little reason why it shouldn't mate.
|
Nice work guys! we do use the factory cut points so you will be in good shape. Excited to see videos of this setup