[anakratis]

Couple things:

- Should have included an indexing pin for the tips (something manufacturers don't seem to think about for zero reason and is quite an annoyance to precisely equally rotate the tips).
- Should have created the axle-back and midpipe to fit most midpipes on the market, as the interplay would have been a huge selling point. Your instructions say to cut at the middle dimples on either side, but a majority of midpipes (Valvetronic, Active Autowerke, Eisenmann, MAD) use the 1st dimple on driver's side and 2nd dimple on passenger's side.

I would have purchased this axle-back if the second point was true, since I was planning to pick up AA's equal length midpipe.