|
Does this basically cover what’s involved with the install of the controller w/ the PnP harness:
-Disconnect the battery negative
-Remove the panel under the glovebox
-Remove the drivers side panel
- Complete wiring in the FEM control unit (no need to do anything under the hood)
-Remove the lower entry trims aka door sills front and rear
-Route the wires through the removed doors sills to the trunk
-Exit the wires through the rubber plug in the trunk floor
-Connect to the EVC’s
-Replace trim/ panels
Does that pretty much cover what we’re looking at with this install?
Also, someone asked good question “
dahler has a kit that plugs into the valve connectors in such a way that the OEM wire plugs into their harness which in turn plus into the valve connector”. Does the AWRON controller use the OEM wires or do we have to zip tie the OEM wires away from the action?
If this install is more or less what I outlined above, PM me pricing for the controller w/ the PnP harness shipped to 02818 and I’ll order it.
|