Quote:
Originally Posted by Dinan_Engineering
We call it out as a 1.5 hour install. First time doing it being extra careful it could be a 2 hour install however. That said, the main engineer who designed the thing and has installed/uninstalled it countless times can do it cleanly in about 20 minutes at this point.
Nothing is cut or removed. We do reccommend bending back some tabs to make sliding the main piece in a bit easier with that extra bit of clearance. Can it be done without doing so? Sure -- just would need to be extremely careful as it will be very tight and the poking tab can scratch the carbon if not careful.
|
Thanks for the reply and input!